AR-5316 Advanced Digital Imager Copier

AR-5316 Advanced Digital Imager Copier

Blinking with L and 1 alternately

Wheni switch on the unit, the display is blinking with Letter L and No. 1 alternately. and the keypads and other buttons is not working. WHEN START THE MECHINE BLINKING L 1

★ ★ ★ ★ ☆ 4.0 stars

AR-5316 Advanced Digital Imager Copier

Product Troubleshooting for AR-5316 Advanced Digital Imager Copier

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Answers :

The L and 1 indicate the scanner carriage is not moving. Something is stopping it. Open the document feeder and turn the copier on while watching the scan carriage (beneath the main glass) - does it move or try to move ? does it make a noise? If it seems to be moving freely for a bit and then stop - is it going back to its "home" position (starting point). Remove the main glass and then move the scan carriage by hand (with the copier turned off) .. does the carriage move ok? check for a loose carriage drive wire or debris or something broken. Make sure the carriage locking screw is not holding it. Then turn the copier back on and see if the carriage makes an attempt to move back to its starting point. if everything seems to be moving ok then the problem could ly with the "home position" sensor. It could also possibly be a bad drive motor.
Having problems with your AR-5316 Advanced Digital Imager Copier ?

Loading ...

Load time: 0.0079 seconds